ZINZINO BalanceTest

Start your health journey 

ZINZINO BalanceTest is the cornerstone of our Balance concept. This advanced analysis delivers precise measurements of 11 key fatty acid levels in your blood, including your essential Omega-6:3 ratio, along with six distinct health markers. Managed independently for unbiased accuracy, your results remain fully anonymous, giving you clear insights into whether your body’s Omega nutrients are properly balanced.

Each test includes personalized recommendations and actionable guidelines to help you restore optimal Omega-6:3 balance and take the next step in your wellness journey.

• Easy-to-use dried blood spot self-test
• Measures 11 fatty acids in your blood
• Provides data about your Omega-6:3 Balance
  

Taking the test
1. Zinzino Test is an approved in vitro diagnostics product for personal blood sample collection at home.

- First wash your hands with soap and rinse well with warm water and dry them.

2. Take out the sample card from the paper envelope. Save the envelope for later use. Tear off the SAVE part on the sample card and take a picture of the test ID. You can only see your test result with your anonymous test ID. Place the card with the two circles facing up on the table.

3. Stimulate blood flow by making big circles with your arm or shaking the hand downwards for 20 seconds.

4. Take out the single-use lancet. Remove the transparent safety cap and the lancet is ready to use. Use the alcohol wipe to clean the tip of your finger (middle finger is recommended). Place the lancet against the lower part of the fingertip facing the collection paper on the table. Push the top of the lancet towards the finger until you hear a click. The lancet will automatically make a small prick in the finger.

5. Do not touch the filter paper with your fingers.

6. Fill one circle at a time with blood. Squeeze your finger gently and wait for a drop of blood to fall inside the circle by itself. If one drop of blood does not cover the circle, allow one more drop from your finger to drip immediately. Leave the sample card in a horizontal position at room temperature for at least 10 minutes for the samples to dry well.

7. Insert the sample card back into the paper envelope. Then place the paper envelope into the metal bag and close it.

IMPORTANT: Do not remove desiccant packet inside the metal bag.

8. Place the closed metal bag into the big envelope with the laboratory address on it.

NOTE! You must put the correct amount of postage stamps on the envelope before you put in the mail box. Register your test code on www.zinzinotest.com. This is the web page where you can see your test result later. It takes 10-20 days until your result is ready.

IMPORTANT: Keep the SAVE part of the card. You can only see your test result with your anonymous test ID.